Mazda 3 door lock problem can be caused by several things such as a bad wiring circuit, bad relay and a bad door lock actuator. The symptoms of this is problem include: Mazda 3 central locking not working: Door lock and handle of the affected door not working properly: Door not opening at all due to its actuator been stuck in the lock position. Is YOUR Saab 9-3 remote locking not working Saab 9-3 remote resynch in under a minute 👍👍🎥 New quality case and battery replacement: nNci central lock not working . Door latch and sjb both fault checking process . Door and dickey lock not working check and found front rhd side door latch fault Managed to get the door open. The manual says turn the key anticlockwise which did not work. Turning key clockwise did open the door but central locking not working on drivers door!! The manual seems set up for left hand drive cars. Is this the same for the fuses. There is a fuse box in front of each door. 1) If Central Locking button works on the center of the Dash, then the issue is with the remote key or the Aerial Diversity which receives the key transmission (when working ;-) 2) If Central Locking button does NOT work then there is likely a problem in the JBE (Junction Box Electronics) Module, either one of the two fuses or one of the relays Solutions: The damaged circuit must be replaced to achieve the proper functioning of the central locking system. But before that, we need to find out the default sensor and look for the reason why the sensor defaults. This data will furnish the root cause to eliminate any short circuits in the future. 4. Gt8Pb.

central locking not working